J'ai postulé via un établissement d'enseignement supérieur ou universitaire. Le processus a pris 4 semaines. J'ai passé un entretien chez Texas Instruments (Dallas, TX) en oct. 2016
Entretien
Applied through university and had one round of phone interview.
Then had a follow up interview on webex.
I was selected for an on-site interview for the final round in Dallas. It was mostly based out on the resume and a few very basic questions about the projects
Questions d'entretien [1]
Question 1
What is the purpose of kelvin connection to measure the resistance of a wire?
Which region of the transfer characteristics represent an ohmic resistor?
He gave me a 3 end to end diode connected transistors and asked me to find the voltage drop across each of them.
fundamental circuit intuition, problem-solving skills, and deep understanding of device physics rather than just rote memorization of equations. You will be expected to think out loud, draw waveforms, and analyze small-signal
J'ai passé un entretien chez Texas Instruments (Bengaluru)
Entretien
Online Assessment followed by 2 rounds of technical interviews. Online Assessment consisted of 3 parts - Analog, Digital and Aptitude. Analog part mostly consisted of questions from RC circuits, Opamps, MOS Circuits, Oscillators.
J'ai passé un entretien chez Texas Instruments (Bangalore Rural)
Entretien
I am only having only one round of interview
Where they asked mostly about rc circuits. Op amp basics and mosfet questions.
The interview almost happened for 1 hour and it is a good experience