J'ai postulé via un établissement d'enseignement supérieur ou universitaire. Le processus a pris 1 jour. J'ai passé un entretien chez Cyient (Hyderâbâd) en nov. 2012
Entretien
First Round is General Aptitude & Technical online test-1hour
Aptitude questions were pretty easy.technical question were also at basic level.
Be good at aptitude even at english to clear this round
Second round is technical interview.If you are able to not to give up for maximum questions asked by ur interviewer you will clear this round.Dont think u will be able to answer all the questions in interview.But try to answer basic level questions correctly
Hr round was a bit general talk.He will study ur attitude depending on the answers u give
J'ai postulé via une autre source. Le processus a pris 1 jour. J'ai passé un entretien chez Cyient (Bengaluru) en mars 2020
Entretien
Starts with an Aptitude Round consisting of almost 25-30 questions following with Technical Interview. Aptitude questions included Speed-time and distance, HCF and LCM, Simple and Compound Interest, Basic Mechanical Engineering related numericals.
Questions d'entretien [1]
Question 1
Difference between 1st Angle and 3rd Angle Projection.
Units of Stress, Strain, Power, Energy
J'ai postulé via un établissement d'enseignement supérieur ou universitaire. Le processus a pris 1 jour. J'ai passé un entretien chez Cyient (Hyderâbâd) en janv. 2017
Entretien
The Interview conducted was not fair. There were 3 panels conducting the Technical round and from the first two panels almost everyone were asked about there project and a few basic Technical questions but in the third panel where I went, they were asking industry level Technical questions. I am not saying they shouldn't but they should consider the fresher status. That was my first interview and because of those idiots, my confidence was down to complete zero and I was totally upset. And not only that first two panels had only one person per panel were as in the third panel there two senior design engineers sitting and expecting an experienced engineer right out of the college. Nobody who went into third panel were selected. But the other two panels selected 15 guys
Questions d'entretien [1]
Question 1
Requirements for selection procedure of a Thrust bearing ?
J'ai postulé via un établissement d'enseignement supérieur ou universitaire. Le processus a pris 2 jours. J'ai passé un entretien chez Cyient (Hyderâbâd) en janv. 2017
Entretien
Written test followed by technical and HR rounds. Written test is similar to that of any other company, verbal ability, logical reasoning and basic mathematics. Technical was all about core and the role domain.